Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
image_modifikations [2016/01/28 16:00] admin [Embedded Artist Image Modifications for Raspbian Wheezy] |
image_modifikations [2016/01/28 16:45] (current) admin [Arduino] |
||
---|---|---|---|
Line 1: | Line 1: | ||
===== Embedded Artist Image Modifications for Raspbian Wheezy ===== | ===== Embedded Artist Image Modifications for Raspbian Wheezy ===== | ||
- | These modifications work with the Raspberry Pi B+, too. | + | These modifications work with the Raspberry Pi B and B+. |
Download and burn the Raspbian Wheezy 2014-09-09 Image:\\ | Download and burn the Raspbian Wheezy 2014-09-09 Image:\\ | ||
[[https:// | [[https:// | ||
Line 35: | Line 35: | ||
$ passwd | $ passwd | ||
- | The passwd command allows you to change your password, you will be prompted for your old password, then you new password twice. The password is " | + | The passwd command allows you to change your password, you will be prompted for your old password, then you new password twice. |
4. Reboot: | 4. Reboot: | ||
$ sudo reboot | $ sudo reboot | ||
- | \\ | ||
---- | ---- | ||
Line 67: | Line 66: | ||
write before exit 0: | write before exit 0: | ||
# run reset and shutdown script | # run reset and shutdown script | ||
- | | + | |
/ | / | ||
- | | + | # start blinking |
+ | printf "start blinking | ||
/ | / | ||
Line 87: | Line 87: | ||
2. For the modification of the GPIO Pin and the Avrdude, the easiest way is to download the setup for the AlaMode board: | 2. For the modification of the GPIO Pin and the Avrdude, the easiest way is to download the setup for the AlaMode board: | ||
- | $ wget http:// | + | $ wget http:// |
- | < | + | < |
unpack it, | unpack it, | ||
$ sudo tar xf paper-duino-pi-setup.tar.gz | $ sudo tar xf paper-duino-pi-setup.tar.gz |