This is an old revision of the document!



IP Selctor with the MCP23008 and MCP23017


Preparing the RPi for I2C:
http://raspberrypi-aa.github.io/session3/i2c.html
http://www.gsurf.de/vorbereiten-des-raspberry-pi-auf-i2c/
Open the file:

$ sudo nano /etc/modprobe.d/raspi-blacklist.conf

Comment out:

#blacklist i2c-bcm2708

Open the file:

$ sudo nano /etc/modules

Add:

i2c-dev

Load modules:

$ sudo modprobe i2c_bcm2708
$ sudo modprobe i2c-dev

Check the i2c modules:

$ lsmod

Module                  Size  Used by
i2c_dev                 3792  0 
i2c_bcm2708             3408  0 

Install some programs:

$ sudo apt-get update
$ sudo apt-get install i2c-tools
$ sudo apt-get install python-smbus

Check the address:

$ sudo i2cdetect -y 1
$ sudo i2cdump -y 1 0x20

Library:
https://learn.adafruit.com/mcp230xx-gpio-expander-on-the-raspberry-pi/overview
Download Adafruit libraries:

$ wget https://github.com/adafruit/Adafruit-Raspberry-Pi-Python-Code/archive/master.zip

unpack:

$ unzip master.zip

Example:
# Set IP Address with MCP23008

from Adafruit_MCP230xx import *

# Use busnum = 0 for older Raspberry Pi's (256MB) # Use busnum = 1 for new Raspberry Pi's (512MB with mounting holes) mcp = Adafruit_MCP230XX(busnum = 1, address = 0x20, num_gpios = 8) # Set pins to input with the pullup resistor enabled for i in range(0,8):

mcp.pullup(i, 1)

# Read pins and display the results #bitshift output, third bit is the output meineIP=0 for i in range(0,8):

print "%d: %x" % (i, mcp.input(i) >> i)
meineIP = meineIP +  mcp.input(i)

print meineIP