Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
image_modifikations [2016/01/28 15:59] admin |
image_modifikations [2016/01/28 16:42] admin [Arduino] |
||
---|---|---|---|
Line 1: | Line 1: | ||
===== Embedded Artist Image Modifications for Raspbian Wheezy ===== | ===== Embedded Artist Image Modifications for Raspbian Wheezy ===== | ||
- | These modifications work with the Raspberry Pi B+, too. | + | These modifications work with the Raspberry Pi B and B+. |
- | Download and burn the Raspbian Wheezy 2014-09-09 Image.\\ | + | Download and burn the Raspbian Wheezy 2014-09-09 Image:\\ |
- | [[http:// | + | [[https:// |
Boot you Rasperry Pi and log in...\\ | Boot you Rasperry Pi and log in...\\ | ||
- | user: Pi\\ | + | user: pi\\ |
pass: raspberry\\ | pass: raspberry\\ | ||
... and make an update:\\ | ... and make an update:\\ | ||
Line 35: | Line 35: | ||
$ passwd | $ passwd | ||
- | The passwd command allows you to change your password, you will be prompted for your old password, then you new password twice. The password is " | + | The passwd command allows you to change your password, you will be prompted for your old password, then you new password twice. |
4. Reboot: | 4. Reboot: | ||
$ sudo reboot | $ sudo reboot | ||
- | \\ | ||
---- | ---- | ||
Line 67: | Line 66: | ||
write before exit 0: | write before exit 0: | ||
# run reset and shutdown script | # run reset and shutdown script | ||
- | | + | |
/ | / | ||
- | | + | # start blinking |
+ | printf "start blinking | ||
/ | / | ||
Line 88: | Line 88: | ||
2. For the modification of the GPIO Pin and the Avrdude, the easiest way is to download the setup for the AlaMode board: | 2. For the modification of the GPIO Pin and the Avrdude, the easiest way is to download the setup for the AlaMode board: | ||
$ wget http:// | $ wget http:// | ||
- | < | + | < |
unpack it, | unpack it, | ||
$ sudo tar xf paper-duino-pi-setup.tar.gz | $ sudo tar xf paper-duino-pi-setup.tar.gz |