Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Last revision Both sides next revision
image_modifikations [2016/01/07 02:20]
admin [Sound on Jack] 		image_modifikations [2016/01/28 16:42]
admin [Arduino]
Line 1: Line 1:
----- +===== Embedded Artist Image Modifications for Raspbian Wheezy =====
-**Embedded Artist Image Modifications** +
-----+
  
-These modifications work with the Raspberry Pi B+, too. +These modifications work with the Raspberry Pi B and B+. 
-Download and burn the Raspbian Wheezy 2014-09-09 Image.\\ +Download and burn the Raspbian Wheezy 2014-09-09 Image:\\ 
-[[http://www.raspberrypi.org/downloads/]]+[[https://www.raspberrypi.org/downloads/raspbian/]]\\
 Boot you Rasperry Pi and log in...\\ Boot you Rasperry Pi and log in...\\
-user: Pi\\+user: pi\\
 pass: raspberry\\ pass: raspberry\\
 ... and make an update:\\ ... and make an update:\\
   $ sudo apt-get update   $ sudo apt-get update
-\\+  $ sudo apt-get upgrade
  
 ---- ----
Line 37: Line 35:
   $ passwd   $ passwd
  
-The passwd command allows you to change your password, you will be prompted for your old password, then you new password twice. The password is "dernulleffekt".+The passwd command allows you to change your password, you will be prompted for your old password, then you new password twice.
  
 4. Reboot: 4. Reboot:
   $ sudo reboot   $ sudo reboot
-\\ 
  
 ---- ----
Line 69: Line 66:
 write before exit 0: write before exit 0:
    # run reset and shutdown script    # run reset and shutdown script
-   printf "start shutdown aund reset button\n"+   printf "start shutdown aund reset button on GPIO 22\n"
    /home/pi/paper-duino-pi/shutdownbutton_02.py &    /home/pi/paper-duino-pi/shutdownbutton_02.py &
-   printf "start blinking\n"+   # start blinking 
 +   printf "start blinking on GPIO 27\n"
    /home/pi/paper-duino-pi/blink_02.py &    /home/pi/paper-duino-pi/blink_02.py &
        
Line 90: Line 88:
 2. For the modification of the GPIO Pin and the Avrdude, the easiest way is to download the setup for the AlaMode board: 2. For the modification of the GPIO Pin and the Avrdude, the easiest way is to download the setup for the AlaMode board:
   $ wget http://dernulleffekt.de/programme/paper-duino-pi-setup.tar.gz   $ wget http://dernulleffekt.de/programme/paper-duino-pi-setup.tar.gz
-<del>[[http://www.wyolum.com/downloads/alamode-setup.tar.gz]]</del>\\+<del>[[http://git.io/alamode-setup]]</del>\\
 unpack it, unpack it,
   $ sudo tar xf paper-duino-pi-setup.tar.gz   $ sudo tar xf paper-duino-pi-setup.tar.gz