Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Next revision Both sides next revision
hdmi_mode [2015/05/25 20:53]
admin 		hdmi_mode [2015/05/25 23:27]
admin
Line 5: Line 5:
 **Change the HDMI mode to a DMT:** **Change the HDMI mode to a DMT:**
  
-3D grafics in Open GL and the OMXPlayer sometimes run into conflicts and the HDMI output stops. The best solution until now is to set the HDMI mode in the configuration file on "mode 2". That means the Raspberry Pi starts allways in an DMT mode (Monitor Mode) and not in an CEA mode (TV Mode).+3D grafics in Open GL and the OMXPlayer sometimes run into conflicts and the HDMI output stops. The best solution until now is to set the HDMI mode in the configuration file on "mode_groupe=2". That means the Raspberry Pi starts allways in an DMT mode (Monitor Mode) and not in an CEA mode (TV Mode).\\
 In: In:
   $ sudo nano /boot/config.txt    $ sudo nano /boot/config.txt 
Line 16: Line 16:
 ---- ----
  
-**manual configuration:**+**Manual configuration:**\\
  
-If the HDMI signal fails when playing a video, set the right HDMI Mode manually.\\+If the HDMI signal still fails when playing a video, set the right HDMI Mode manually.\\
 [[http://www.raspberrypi.org/forums/viewtopic.php?f=28&t=7513]]\\ [[http://www.raspberrypi.org/forums/viewtopic.php?f=28&t=7513]]\\
 [[http://elinux.org/RPiconfig]]\\ [[http://elinux.org/RPiconfig]]\\